Differences between revisions 9 and 10
Revision 9 as of 2009-04-08 16:07:42
Size: 1925
Editor: Anderson-Camtasia
Comment:
Revision 10 as of 2009-04-12 23:05:18
Size: 1969
Editor: 24-183-238-75
Comment:
Deletions are marked like this. Additions are marked like this.
Line 34: Line 34:

= Often Discussed Topics =

   * IpSec

CPTR 427 Network Security Class

Labs

SSL and code signing lab:

Hints: To get a code signing template to show up on the web page, you need to add it to the templates. Just go into the CA and right click templates and select new.... DO NOT ADD your site to the trusted sites list in windows. This will cause you problems. If at first you don't succeed, close it all and restart IE.

Windows NTFS/Share Permissions Lab

RSAT (Remote Server Administration Tools) has replaced (somewhat) the Support Tools. At any rate you can get them here:

xcacls has been replaced by Icacls in Vista and Windows 2008.

Using WebScarab with WebGoat

  1. Start up WebScarab. It may be in basic mode.

    1. If it is, Go to Tools->Use Full Interface.

    2. Restart WebScarab.

  2. Fire up IE and go to Tools->Internet Options->Connections->LAN settings.

  3. Check Use proxy server and set address to localhost port 8008.
  4. Click OK and OK.
  5. On WebScarab go to Proxy->Manual Edit. Check Intercept Requests. Select GET and POST (using the CTRL key to select both).

  6. In IE go to http://localhost./WebGoat/attack. (notice the dot after localhost, it is required to apply proxy settings on localhost.) WebScarab should already start intercepting. The lessons should work after that. I was able to do a command injection following the steps in the solution. I have now put the proxy settings back to the way they were and shut down WebGoat (for security reasons, not sure if that was necessary but I did it.)

Often Discussed Topics


CategoryHomepage

NetworkSecurity (last edited 2024-01-07 18:12:17 by scot)