Differences between revisions 36 and 37

Lab 01

Installing Windows Server, the firewall and a basic network.

Please read the entire lab before starting.

Assignment

First read the naming convention before you do anything!

Create 3 virtual machines:

pfSense/OPNSense
Windows 10 Client
Windows Server 2019 Standard (If you install the desktop experience, you will have to re-install it)

Create a homepage on your Documentation Wiki and include links to the following pages:

Document the configuration of your network in a new page called “Networking" using the principles of documenting that we went over in class. Draw a diagram like you see on the wiki, but make sure it has your correct IP addresses.
Document the process of installing Windows Server (Screen shots are good documenting choices during the install) in a new “Install” page of your wiki on moodle.
Document your passwords in a new "Passwords" page of your wiki.

Create a video that shows your working Windows Server installation working. Include a walk through of your wiki pages.

Topics	Points
Video shows working windows 2019 installation (ping internet from commandline)	20
Video Shows working windows 10 installation	20
Video talks through your Networking Documentation	10
Video talks through your Installation Documentation	10
Video Talks through your Passwords Documentation	10
Wiki contains a home page with links to the three pages listed above	30

WindowsAdministration/Lab01ConfigureLinuxInstallWindowsServer (last edited 2024-09-05 17:22:03 by scot)

-  ⇤ ← Revision 36 as of 2021-09-02 22:11:06 → 
  Size: 2649
  Editor: scot
  Comment:
+   ← Revision 37 as of 2021-09-02 22:18:50 → ⇥
  Size: 1687
  Editor: scot
  Comment:
-Deletions are marked like this.
+Additions are marked like this.
 Line 15:
-=== Installing Windows Server ===

Install Windows Server on one of your remaining VMs.

On windows setup your network with the following information:

 * IP address 192.168.1.2
 * Gateway 192.168.1.1
 * DNS 10.10.129.2 and optionally 10.10.129.3 (We will change this soon)

To do this, run sconfig (if you have a GUI, you are doing it wrong). While you are at it, make sure you've got all of the following configured:

 1. [no change]
 1. Set to CPTE230A
 1. [no change]
 1. Enable remote access
 1. [no change]
 1. [no change]
 1. Enable remote desktop
 1. Configure your network settings here. 
 1. Set the timezone to Eastern
 1. [no change]
 1. If you haven't done it yet, enter the key and activate your server
 1. [No change ....] 

{{attachment:sconfig.png||width=800}}

Start your Windows Server to installing updates.

Make sure you can access the Internet and that you can remote desktop into your Windows 10 machine. 

'''To earn points:'''
+== To earn points: ==